Doberman Forum : Doberman Breed Dog Forums banner
Status
Not open for further replies.

How to: Posting Show Cropped Ears Using Backer Rod

1 reading
94K views 17 replies 10 participants last post by  melbrod  
With your puppy on your work surface put a small amount of powder in the base of each ear. The Neo-Predef bottle is great for this as it only has one tiny hole and you can just squeeze it in there. Massage the ear a little bit to distribute the powder.

Image


Cut 6 strips of zonas tape, 2 longer, 4 shorter and have them in a handy spot to grab.

Image


This step is very important to have a successful posting job. You need to really stick the post down in the ear and stretch the ear on to the ear post, sticking it to the ear leather. If you do not stretch enough the post WILL pop out. If you added the bumpers like I did, rotate the post so that the bumper is pushing out on the weak spot (sometimes called a pocket when it's very severe). This is towards the inside of the ear near the front.

Image


While still holding your puppy's post in his ear, grab a long section of zonas tape that you already cut. Stick the tape to the POST with the extra tape going towards the front of his head. Put the tape down low, at an upward angle.

Image


gently lay (do not "pull") the tape around the front of the base of the ear making sure that the natural fold in the ear lays back on itself the way it wants to, which is, "naturally" :wink2: I can't stress how important it is not to pull the tape but "lay" it on. Taping too tightly will cause sores, or worse.

Image


Bring the tape all the way around and "scrunch" it around so the post is secure at the base.

Image


Now, move to the top of the post. With one of the smaller sections of tape, gently lay the tape around the ear tip making sure to cover all the way to the tip and slightly past it. It is good practice to go the same direction as you did on the base of the ear so the natural fold goes the way it wants to although it is not as important on the very tip here.

Image


Image


Image


For the middle section use another smaller piece of tape that you've already cut. Start the tape on the post, and again, bring it around so that the natural fold of the ear lays back on itself. Again, don't pull, just lay the tape around and scrunch it on so it's secure.

Image


Image


You're all done with one side!

Image


Just snap your fingers and like that the other side is done too :wink2:

Image


This photo shows where to cut the post. VERY carefully cut the excess off at the purple line. The green line is where the ear tip ends. Be extremely careful to not cut the ear. Feel with your fingernail where the ear ends.

Image


Admire your new "pro" posting job

Image


Image
Thank you so much. This is exactly what I prepped for. Adding the zip ties is better than dbl up duct tape. Extremely helpful! I let you know how it goes!
 
Status
Not open for further replies.
You have insufficient privileges to reply here.